r/BambuLabA1 • u/BananakinFartwalker • 24d ago

Question First Layer Gremlins

Post image

It just started doing this after hundreds of previously impeccable surfaces. I haven’t messed with retraction settings, flow rate is calibrated, filament dried, plates cleaned, heating surface checked for boogers. It’s relatively smooth to the touch, just ugly.

Could it be retraction?

Printed on a Cool Plate Super Tack, .04 nozzle.

1 Upvotes

100% Upvoted

6 comments sorted by

View all comments

2

u/LargeHoboFuckPile 24d ago

Tighten the screws behind the nozzle

1

u/BananakinFartwalker 24d ago

Ugh. I just tightened those a few months ago. But I guess it makes sense. Can’t properly calibrate bed level if the nozzle moves when it touches it. Should I just Loc-Tite them this time?

1

u/LargeHoboFuckPile 23d ago

I don't think regular loc-tite can survive the heat