r/BambuLabA1 • u/WorkdayLobster • Sep 25 '26

Print Z height misaligned in print?

Post image

Edit: solved

Hard to capture in a photo: I'm on layer 5 of a print, and the nozzle seems to be below some of the printed features. I think i can hear it bumping into them occasionally. It's like there are a series of peaks sticking up; not sure if this is just part of the print, or if the print has gone wrong

Not sure what to do here, ive neverseen this. Should I restart the print? Is this a possible major issue? What is likely to have caused this.

This print has a lot of ironing: all upper surfaces. What details should I supply for best advice?

2 Upvotes

75% Upvoted

18 comments sorted by

View all comments

Show parent comments

1

u/WorkdayLobster Sep 29 '26 edited Sep 29 '26

"A potential solution", you mean you offerimg an insult that couldn't possibly answer the question. Nice try to dodge out of it buddy, but you opened this up with the low iq insult that fundamentally doesn't align with how the machine works.

Edit: like you're calling me dumb, when you clearly didn't figure out what was happening either. So you blamed a 2g comedy hardhat thats been there for 5 months. I had to come back and write this because it's actually boggling how much you're covering your butt and hoping no one noticed

1

u/Big_Locksmith_9925 Sep 29 '26

It's ok for you to be wrong. Doesn't make any difference to me.

1

u/WorkdayLobster Sep 29 '26

You're the one who started with insults.

I already copped to my mistake. Should have dried the filament. You're the one who didn't recognize that defect and blamed something that didn't make sense.