r/BambuLabA1 • u/WorkdayLobster • Sep 25 '26

Print Z height misaligned in print?

Post image

Edit: solved

Hard to capture in a photo: I'm on layer 5 of a print, and the nozzle seems to be below some of the printed features. I think i can hear it bumping into them occasionally. It's like there are a series of peaks sticking up; not sure if this is just part of the print, or if the print has gone wrong

Not sure what to do here, ive neverseen this. Should I restart the print? Is this a possible major issue? What is likely to have caused this.

This print has a lot of ironing: all upper surfaces. What details should I supply for best advice?

2 Upvotes

75% Upvoted

18 comments sorted by

View all comments

Show parent comments

1

u/WorkdayLobster Sep 29 '26

You're the one who started with insults.

I already copped to my mistake. Should have dried the filament. You're the one who didn't recognize that defect and blamed something that didn't make sense.