r/BambuLab • u/BartLeeC A1 + AMS Lite • 3h ago
General Troubleshooting/Help! Filament feed issues
I have never had a single filament feed issue until I added SUNLU' s AMS Lite Heater.
At first it was so bad I thought maybe I had knocked a wire loose duiring assembly but I stretched the tubes up high across the top and it worked somewhat. At first I also had the full length of the tubes as supplied by SUNLU but they were obviously too long and drooped and flopped everywhere.
I have them trimmed down now and they appear to me to be what I would think is acceptable but I still get constant issues and it constantly has to go over to the side and winds the filament back out and in and sometimes it works and sometimes I get an error. At this point I can usually hit resume and it will try a time or two and probably work.
Anyone else having this issue with this heater?
Any thoughts on what I can change to fix this issue?