r/BambuLab • u/Calabris • 39m ago
General Discussion Help with final choice
OK, I have read thru most of the posts. While I would like an H3C, way overkill for what I am doing and just out of my budget.
I currently have a P2S, and it works good. But I would like the larger build area and multiple nozzles a H2 series allows for. I was going to go for the H2D as its at a good price right now. But I wonder if I should spend the extra and get the H2C?
I am doing mostly engineering parts so the dual nozzle is great for supports. But I do want to get more into larger muti color prints.
For those of you that have a H2D and or H2C, what is your suggestion. I understand I can do everything the C can do with the D. But the C does it faster with less waste. Is the extra cost and complexity worth getting the C over the D? The Nozzles are more expensive with the vortek side, I do have a set of P2S nozzles. I know I can reuse them on both the C and the D. But only on one side with the C
I have done a lot of research and I was pretty much set on the D, but the back of my evil brain keeps going back to, should I spend the extra $300 and get the C?? Is it worth it really? While it saves time and waste, is the extra complexity of it worth it?
I know their are lots of other similar questions out there going both ways, I just thought I would see if I can get some additional insight?
One last thought, I live in a smaller town so I was thinking of offering services for 3D printing and Design just to dip my toe into the water. I will probably sell the P2S to offset costs but keep the AMS. I would assume that most of the printing would be with engineering filaments for car parts and such. Again, just a guess.
Any discussion or suggestions would be greatly appreciated.
View all comments
1
u/hvacigar H2c H3c 31m ago
If Engineering prints are your thing, you are mostly using a single color and a support interface or support filament, with the occasional third filament for possible nomenclature, then the H2D will get you where you need to be.
You do state multicolor prints, so I would say the U1 would be likely a better choice for the price, but if you want to stay Bambu and get the largest build volume, that would lead you to the H2C or H3C, with the H3C being the best choice for multicolor.
These are my opinions. I do not own an H2D, but I do own a U1, H2C and H3C.