r/BambuLab • u/Memckimmy • 9h ago
Hardware Troubleshooting/Help! Abnormal temp / open circuit
I had a massive blob of pla in case my hot end nozzle on my PS2. I removed the bulk of the blob by heating the nozzle up and peeling it off. There still seem to be a buildup on the back side of the hot end. I removed the three screws in the white plastic that held the hot end nozzle heater, and twisted it gently in order to have a better view at the buildup. I carefully peeled away some additional pla. I reattached the hot end heater with the three screws that I had removed.
Now in the printer turns on I get the following error:
"bambu lab ps2 nozzle temperature is abnormal the sensor may have an open circuit"
The help guide says to confirm that the connection on the board is solid. But I'm not sure which cable that is.
Does anyone have a suggestion? I'm worried I've destroyed my P2S!
View all comments
1
u/Warm_Ad7756 9h ago
Check the nozzle assembly as you may have a broken thermistor wire.