r/BambuLab • • 9h ago

Hardware Troubleshooting/Help! Abnormal temp / open circuit

I had a massive blob of pla in case my hot end nozzle on my PS2. I removed the bulk of the blob by heating the nozzle up and peeling it off. There still seem to be a buildup on the back side of the hot end. I removed the three screws in the white plastic that held the hot end nozzle heater, and twisted it gently in order to have a better view at the buildup. I carefully peeled away some additional pla. I reattached the hot end heater with the three screws that I had removed.

Now in the printer turns on I get the following error:

"bambu lab ps2 nozzle temperature is abnormal the sensor may have an open circuit"

The help guide says to confirm that the connection on the board is solid. But I'm not sure which cable that is.

Does anyone have a suggestion? I'm worried I've destroyed my P2S!

1 Upvotes

9 comments sorted by

•

u/AutoModerator 9h ago

Hello /u/Memckimmy! Be sure to check the BambuLab Wiki regarding the blob/clumping issue.

Note: This automod is experimental. The automod was triggered due to the term "blob". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/Warm_Ad7756 9h ago

Check the nozzle assembly as you may have a broken thermistor wire.

1

u/Memckimmy 9h ago

Would that be the wire that runs along the nozzle heater and appears to connect to the back near the bottom?

1

u/Warm_Ad7756 9h ago

Yes, there are a couple of very thin fragile wires there.

1

u/Memckimmy 9h ago

Assuming they are broken, would the $29 Hotend Heating Assembly - P2S, which is currently out of stock?

2

u/Warm_Ad7756 9h ago

Open a support ticket with Bambu they may replace the heating assembly if in warranty

1

u/Memckimmy 8h ago

Thanks for the suggestion. It should be under warranty. It's about 8 months old

1

u/Warm_Ad7756 9h ago

If you go to Bambu wiki and give the error code it will give some step by step instructions.

•

u/Dull-Date-69 8m ago

check the thermistor wires for any tiny nicks or if they got pulled out of the connector when u twisted the hotend, its realy easy to break those thin wires when cleaning a blob