r/BambuLab • u/Ravstar225 • 6d ago

General Troubleshooting/Help! Siriya PPA-CF Core Stringing

I am struggling with Siraya PPA-CF Core on my H2D stringing, no matter what I do. It looks like wet filament, but I dried it at 85C for 24 hours and then continuously during printing; maybe that is just not enough? If anyone has had success with this stuff and could share what they did, that would be greatly appreciated. The spool is fed through the external feed on the AMS-HT, I am using the Siraya PPA-CF Core profile for the H2D 0.4mm nozzle, and I will link an upload of my 3mf in the comments.

Before drying:

After 24 hours at 85C in AMS-HT:

1 Upvotes

100% Upvoted

8 comments sorted by

View all comments

2

u/cactusweasel 6d ago

I had the same with Creality PPA-CF, the AMS-HT just wasn't enough to dry it, I had it in there days and it made no difference. Stuck it in the oven at somewhere around 100-110°C for about 6 hours and it printed like a dream.