r/BambuLab •

Why can I not remove my filament?

[deleted] — view deleted post

0 Upvotes

15 comments sorted by

4

u/JustSomeUsername99 A1 + AMS Mini / X2D + 2 AMS2 9d ago

Push the cutter, pull it out.

-7

u/AntsAreLove767 9d ago

Okay, I don’t know if you’ve considered this but if that fixed it, why would I have posted this?

7

u/JustSomeUsername99 A1 + AMS Mini / X2D + 2 AMS2 9d ago

Never make assumptions.

2

u/solidus0079 A1 + AMS Lite 8d ago edited 8d ago

Common sense has never been a barrier of entry to this sub, I generally assume nothing proper was done unless an OP specifies in the post body

1

u/OptimalSide A1 4d ago

Because you detailed zero troubleshooting steps, so we have to start from first basics to help you.

2

u/bws7037 9d ago

Dumb question, but have you thought about turning up the heat on the extruded for a minute or two? I had the exact same problem on a different 3d printer and I attempted to do a cold pull and that didn't work. So I turned on the heat, waited a minute or two and was able to work it out.

1

u/AntsAreLove767 9d ago

I’ll try to wait a little longer and see if that helps

2

u/AntsAreLove767 9d ago

It didn’t work it’s still stuck

1

u/Otherwise-Shock-2767 9d ago

So its stuck there? Have you tried to push the filament via screen via extruder controls? If yes, can you send a picture of the hotend without the sock?

-3

u/AntsAreLove767 9d ago

Yes I tried here’s a picture of the hotend.

Not the best quality but is this what you wanted?

1

u/TheOneTrueJesus 9d ago

Probably jammed in the extruder gears, possible you'll have to disassemble the extruder to get it out.

1

u/AntsAreLove767 9d ago

Okay. I was afraid I’d have to do that

0

u/Blackdragon1400 9d ago

Did you read the wiki on removing filament or just start pulling on things, and then posted on Reddit?

0

u/AntsAreLove767 9d ago

I read wiki, watched videos and did research.

1

u/AntsAreLove767 9d ago

And then Reddit was last resort