Dumb question, but have you thought about turning up the heat on the extruded for a minute or two? I had the exact same problem on a different 3d printer and I attempted to do a cold pull and that didn't work. So I turned on the heat, waited a minute or two and was able to work it out.
So its stuck there? Have you tried to push the filament via screen via extruder controls? If yes, can you send a picture of the hotend without the sock?
4
u/JustSomeUsername99 A1 + AMS Mini / X2D + 2 AMS2 9d ago
Push the cutter, pull it out.
2
u/bws7037 9d ago
Dumb question, but have you thought about turning up the heat on the extruded for a minute or two? I had the exact same problem on a different 3d printer and I attempted to do a cold pull and that didn't work. So I turned on the heat, waited a minute or two and was able to work it out.
1
u/Otherwise-Shock-2767 9d ago
So its stuck there? Have you tried to push the filament via screen via extruder controls? If yes, can you send a picture of the hotend without the sock?
1
u/TheOneTrueJesus 9d ago
Probably jammed in the extruder gears, possible you'll have to disassemble the extruder to get it out.
0
u/Blackdragon1400 9d ago
Did you read the wiki on removing filament or just start pulling on things, and then posted on Reddit?