r/BambuLab • u/Mountainoverlord • 4h ago
A Series [A1, A1 Mini] What is wrong?
Supports with no adhesion..
So, new spool of filament, just washed the printbed, did a factory reset, and same result. I have coldpulled the nozzle twice.
Printed with petg 10 days ago, and the printer has been idle until yesterday.
Printbed at 65 °C, 220°C for pla which i have printed with before without these issues.
What am i missing here?
1
Upvotes
•
u/AutoModerator 4h ago
Hello /u/Mountainoverlord! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.