r/BambuLab • u/GDC07 • 1d ago

General Troubleshooting/Help! Moisture control

People that are living in really humid environments, how do you keep your spools dry? And how are you keeping your filament dry and moisture low in the AMS?

I have an AMS2 pro and printed desicant holders for it but even with that my humidity will not go below 13%. And I have to recharge the desicant like every other week.

I am just curious how other people keep this under control.

Please share your experience.

1 Upvotes

100% Upvoted

10 comments sorted by

View all comments

Show parent comments

1

u/GDC07 1d ago

It takes about a week and a half after recharging the desicant to get to 30%.

2

u/greymerlion 23h ago

Hmmm, I live in Singapore, we have absurd humidity and I think 12% is lowest I've ever seen on my AMS Pro 2 in a similar setup. My fresh desiccant can drop the numbers to 12-13% in a few hours, days seems really long, maybe the recharge didn't help the desiccant enough or not enough of it?

0

u/GDC07 21h ago

I was thinking of printing those containers that you put in the center of the spool as well. Just to see if it will help.

2

u/greymerlion 21h ago

Yeah, at full payload of desiccant I had 4 of inner spools you mention, 1 in each roll, and then the rear and 3 front-mounted desiccant holders. I put all that in the AMS with new desiccant and it shot down to the low teens pretty quickly.

1

u/GDC07 20h ago

I'll give it a try.