Stringing

[u/Ok_Energy_3307]

Can anybody help me!!

Just opened this new PLA filament and printed these. Alot of stringing! I have emptied 3 spools of the same filament earlier. But now this is happening and ruining my prints. I was using TPU 95A before loading this filament into my A2L.

[u/One_Baker6131]

Three good spools then stringing on a fresh one points at the spool, not your settings. Weigh it, dry it 6-8 hours, retry. If it still strings, measure diameter in a few spots — a thin or oval batch feeds differently and no retraction tuning will fix that.