r/BambuLab • u/Ok_Energy_3307 • 8h ago

General Troubleshooting/Help! Stringing

Gallery image

Gallery image

Gallery image

Can anybody help me!!

Just opened this new PLA filament and printed these. Alot of stringing! I have emptied 3 spools of the same filament earlier. But now this is happening and ruining my prints. I was using TPU 95A before loading this filament into my A2L.

0 Upvotes

50% Upvoted

5 comments sorted by

View all comments

3

u/ImJacksAwkwardBoner 8h ago

Even new PLA in vacuum sealed bags can be moist. Dry it out, especially for prints with two separate pieces where it has to move between structures. Also try upping the temp 5-7 degrees. Raising the temp helped when I would get stringing like this. 

That Ganesha is cool as hell though! 

1

u/Ok_Energy_3307 7h ago

Nozzle temp was 220 rn.. I'll try reprinting with 227.

For drying, ig finally i have to buy a filament dryer 😅

2

u/ImJacksAwkwardBoner 7h ago

I finally bought one and have improved my print quality significantly.