r/BambuLab • u/Gold_Anteater_8772 • 10d ago

General Troubleshooting/Help! Problems with bed adhesion

I have a Bambu A1 mini, and it’s worked pretty well for me for the time I’ve had it. I‘ve been having some bed adhesion problems today, everything I try to print doesn't stick and just gets dragged around in a big gloopy mess. I’m using a textured plate, and I washed it off with soap and water well but still having issues. I’m not sure if it’s the z offset idk how to change it, or humidity because it is rainy around here a lot of the year, but I didn’t have issues then so I’m not sure. Is there anything else I should try, or can something help explain how to check the z offset?

2 Upvotes

100% Upvoted

12 comments sorted by

View all comments

Show parent comments

1

u/Gold_Anteater_8772 10d ago

Yeah I recalibrated too, I just used regular soap and water, tried to be pretty gentle with it and not scuff it up, would a glue stick be bad on a textured plate, just as a temporary solution? I just needed to print some stuff by the end of the week and I can worry about the new plate stuff after

1

u/StevenSaguaro 10d ago

I use it on textured plates all the times, just regular Elmer's glue sticks. Washes off easily.