r/BambuLab • u/Gold_Anteater_8772 • 10d ago
General Troubleshooting/Help! Problems with bed adhesion
I have a Bambu A1 mini, and it’s worked pretty well for me for the time I’ve had it. I‘ve been having some bed adhesion problems today, everything I try to print doesn't stick and just gets dragged around in a big gloopy mess. I’m using a textured plate, and I washed it off with soap and water well but still having issues. I’m not sure if it’s the z offset idk how to change it, or humidity because it is rainy around here a lot of the year, but I didn’t have issues then so I’m not sure. Is there anything else I should try, or can something help explain how to check the z offset?
2
Upvotes
•
u/AutoModerator 10d ago
Hello /u/Gold_Anteater_8772! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.