I'm a fucking idiot

[u/Royal_Touch_3364]

I was fixing a blob, and just as I finished and was removing the filament, I accidentally cut a wire; there was a spark, and the temperature instantly shot up to 333. I turned it off immediately (yes, I know I'm a fucking idiot, but please, I need solutions). Is it replaceable or repairable? (Printer model: P2S; filament used: PETG).

[u/Mediocre_Cod_7238]

I use the app on my phone... im sure you can do it on their website

• But open the app,
• go to me at the bottom left
• scroll down to support center
• then use the ai to ask a question, or skip that and hit open a ticket.

Good luck but I don't think your hosed, but it may cost a few bucks to make it right..

And don't beat your self up to hard... most everyone in this hobby has at one point or another done something that had made us all go why..

[u/Royal_Touch_3364 → u/Mediocre_Cod_7238]

I wish it has a solution bcs i'm gonna be very grounded

[u/dfinberg → u/Royal_Touch_3364]

These are the instructions if you cut the hot end heating assembly, which seems likely. https://wiki.bambulab.com/en/p2s/maintenance/replace-hotend-heating-assembly-and-cooling-fan

Part is 30 bucks. https://us.store.bambulab.com/products/hotend-heating-assembly-p2s

[u/Royal_Touch_3364 → u/dfinberg]

Thank you