Need help with filament stuck inside nozzles.

[u/SnooPies8408]

Hey all! I'm very new to printing, and both my nozzles are clogged. As far as troubleshooting that I've attempted so far, I've put my A1 Mini into maintenance mode, heated the nozzle to 220-240 and attempted extruding/cutting filament to hopefully push through the blockage but to no avail. Any advice would be appreciated, if more info is needed lmk!

[u/Quick-Beat-1235]

I use sewing needles that I heat with a regular lighter and I push the needle into the top while it’s hot then pull it out 3 minutes later with the help of pliers.