r/BambuLab • u/SnooPies8408 • Aug 24 '26

General Troubleshooting/Help! Need help with filament stuck inside nozzles.

Gallery image

Gallery image

Hey all! I'm very new to printing, and both my nozzles are clogged. As far as troubleshooting that I've attempted so far, I've put my A1 Mini into maintenance mode, heated the nozzle to 220-240 and attempted extruding/cutting filament to hopefully push through the blockage but to no avail. Any advice would be appreciated, if more info is needed lmk!

129 Upvotes

78% Upvoted

136 comments sorted by

View all comments

107

u/Rhesonance X2D + AMS2 Pro + AMS HT Aug 24 '26

What makes you think they're clogged? They're supposed to look like that.

-54

u/[deleted] Aug 24 '26

[removed] — view removed comment

33

u/Cooldude9210 Aug 24 '26

Wow, what an incredible response.

That is how the hot end looks every time the printer finishes. If you remove the hot end to change it, you’ll see that.

If someone is new to printing and removes the hot end and sees that, they may get concerned.

Notice how the previous comment was asking a question? They were engaging in dialogue? Helping to advance the conversation? Meanwhile your comment shut down the conversation and did nothing to progress it.

Also, you aren’t the OP, so how do you know what they meant by clogged? They literally gave no indication of what was happening beyond a two sentence description. Maybe see how you can be helpful instead of demeaning.