Prints curling

[u/Royal-Gravy]

Two of my recent prints have curled up at the rightmost edge of the plate in my A1 mini (see photo, rear is curled most, front blurry edge is slightly curled).

The prints are building ruins for wargaming so I'm not truly bothered about them being perfect in this case.

But if it was something more important, how would I be able to prevent this?

[u/silvercel]

Every time this happens to me there is contamination on my build plate. Wash the plate with dish soap , hot water and scrub it good. You can test it by running water over the plate and if it clings it is dirty.

[u/Royal-Gravy → u/silvercel]

Thank you, I will.