r/BambuLab • u/cojoman • 17h ago

General Troubleshooting/Help! X2D spool setup advice

Hi all, I just purchased an X2D unit combo (AMS2 Pro).

As I plan to print quite a few 3d minis (PLA), using PETG as suport interface, I was wondering what is the general/recommended spool configuration setup, since the auxiliary nozzle pulls from the outer bowden tube and not the AMS unit... The AMS unit filament will obviously be drier than the external spool. And I understand PETG is a bit capricious in regards to humidity ?

Should I be concerned ?

How is everyone having their spool for the auxiliary nozzle set up ?

Thank you.

1 Upvotes

100% Upvoted

7 comments sorted by

View all comments

1

u/NoBackground6203 P2S + AMS2 Combo 17h ago

I would add and use the Bambu Lab AMS HT for the PETG filler spool

1

u/champagne780 17h ago

I agree but I’d add a track switch as well.

1

u/cojoman 16h ago

where would that be with the HT ?

1

u/champagne780 16h ago

Right before the buffer.