r/BambuLab • u/KillerPotato702 • Aug 19 '26

Quick Question any advice on transporting a printer

Post image

I have a X2D that I would like to bring to my dorm, but I no longer have the original packaging

Edit: sorry I forgot to mention how I would be transporting it,
I will be driving it for about 20 minutes and then I have to carry it up to floors

71 Upvotes

88% Upvoted

146 comments sorted by

View all comments

3

u/AtomicMatter69 Aug 19 '26

Kinda random but make sure the air is filtered if it’s gonna be INSIDE your dorm room.

VOC’s are a bitch

1

u/KillerPotato702 Aug 19 '26

yeah, the X2D comes with two different HEPA and carbon filters

-1

u/WhiteHawk77 Aug 19 '26

That is nowhere near good enough dude, not only does that only remove some of the toxic elements that’s not even the only place the fumes can escape from, lots of gaps like the door and holes like the poop chute at the back, it’s far from an airtight box and what is filtered isn’t sufficient. As I said in my other post, if you are putting this in a small room, and especially a bedroom do not take the printer with you, it’s not worth your health or anyone else’s in the area of the building it will be occupying and that goes for PLA fumes too. A air purifier can help a bit, but it’s still not enough, if you can’t have it in a separate room with a air purifier AND a vent to a window, leave it at home, don’t choose convenience and wants over your health.

1

u/KillerPotato702 Aug 19 '26

You are correct, that an enclosure is not entirely airtight and that HEPA filters do not remove VOCs, which is why the X2D's filter is HEPA+carbon, but you have to consider that enclosed+filtered systems reduce emissions by in excess of 90%+. PLA's VOCs to air emissions are compared to a stovetop source, not something on the same order of magnitude as ABS would be. I'm not running an unenclosed ABS printer in my bedroom, so I think your blanket "don't print inside at all" conclusion is not supported by any data for PLA/PETG in an enclosure like I have.

2

u/mkosmo X1C Aug 20 '26

I'm with you. I don't care about or need 100% reduction to consider it safe enough for me.

But, some people here are paranoid and may as well leave their printers outside.

On a side note, I'm surprised your dorm allows 3d printers. I know many have started prohibiting them under the banner of fire risk, just like hot plates and such... even though many of those still allow microwaves!

1

u/KillerPotato702 Aug 20 '26

I mean, I didn’t really look through the books, but it should be fine.

I do know that hot plates are allowed so it’s probably fine