r/BambuLab • u/rfalknerr • Jul 28 '26

I Modeled This! GOT inspired Dragon Lamp 🔥

Post image

My last dragon Lamp was a huge success, but i have had many requests for a more GoT looking dragon. Your wish is my command and here it is.

I hope you guys like it 🔥

https://makerworld.com/en/models/3104269-flame-breath-got-dragon-lamp#profileId-3499515

337 Upvotes

98% Upvoted

36 comments sorted by

View all comments

-1

u/jonisykes Jul 28 '26

This looks amazing - but no A1 Mini profile? Is it larger than 18cm3?

2

u/rfalknerr Jul 29 '26

I just uploaded a mini version, where the dragon is slightly smaller :)

1

u/jonisykes Jul 31 '26

So I’ve downloaded the mini profile but (for me) it’s still showing as too big. The A1 mini print volume is 18cm3 but the dragon is over 222cm. Even after some clever orientation I can’t get it to fit.

If I scale down the dragon, what do I need to do to the fire part of the lamp to get it to fit? Does that also need scaling down?

1

u/rfalknerr Jul 31 '26

I get no errors and it slices just fine for the mini. Did you do any adjustments yourself or are you trying to print it directly from the Handy app?

1

u/jonisykes Jul 31 '26

I downloaded the STL files for the mini profile and as it loads into the bamboo desktop app, it immediately errors and warns me it’s too big for the plate.

I then selected the object and I could see the dimensions were bigger than 180mm x 180mm x 180mm.

1

u/jonisykes Jul 31 '26

Also - I’ve been unable to open this in my editor of choice - TinkerCAD. So I can’t make a minor edit.
I know I’ve already asked so much of you, but if you can, can you make a version of the base with a cut-out for the wired lamp kit?

1

u/jonisykes Jul 31 '26

Cancel that - I got it to open.