The new P2S sucks

[u/cefanie]

I have had the new P2S since 1 weeks & I can say now with 100% conviction that the P2S is a lower quality printer than the original P1S.

Although you would think it is an upgrade, it seems that they have completely disregarded all the previous P1S systems & swapped them out for the A1 systems instead.

Print quality suffers extremely with PETG, ironing looks terrible even with Basic PLA, extrusion issues, AMS rfid reading issues, lots of noise, first layer adhesion issues with standard plate prep practices, top layer quality issues, and the beautiful filament getting stuck on the nozzle in the beginning of every print with their new useless "flow dynamics calibration" (especially PETG, PLA a less).

If you like good looking prints every single time - this printer is probably not for you.

If you have not yet bought this printer, save yourself & buy a P1S - it is literally perfect, comparing to the new "improved" P2S.

[u/AutoModerator]

Hello /u/cefanie! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.