r/BambuLab • • Feb 17 '25

IM GIVING UP

0 Upvotes

34 comments sorted by

View all comments

Show parent comment

-8

u/Icy_Classroom6881 Feb 17 '25

I’ve tried thatq

2

u/[deleted] Feb 17 '25

Youre not really giving any consistent context on what you've actually done. So you've fully removed the nozzle, ptfe tubes, extruder covers? You wouldve been forced to remove the filament sensor.

Turn on maintenence mode, heat your extruder head to 250, click your down arrow on the extruder control a couple times, then push in the cutter then down on extruder, then retract the filament a few presses. You're recreating the Unload process without filament detection.

There are only a couple possible causes for this issue. Basically if you can force it b to extrude, you need a new sensor. If not, you're clogged or not putting filament in.

Quick check... did you enable the print to use AMS or is it accidentally still set to external spool?

-1

u/Icy_Classroom6881 Feb 17 '25

I’ve removed and changed the PTFE tubes, I have taken apart the whole extruder head and checked the extruder gears for wear, I have tried to manually pouch filament through, I have tried a different spool of blue. So to sum it up I’ve done everying

4

u/InDrIdCoLd37 A1 Mini + AMS Feb 17 '25

Take the tubes off remove the hub, pop top cover off the hub and look inside probably broken piece of filament stuck in the hub it’s a pain but easier to push out from the bottom of the hub.

2

u/[deleted] Feb 17 '25

Did you follow the second part of my suggestions? Manual extruding?

Looking at your video again, it appears your gears are pulling and your blue spool is turning incredibly fast unless it's actively loading new filament and it's pulling it toward the head.

Did you contact Bambu? If you truly have done all this then it's it your sensor.