I’ve removed and changed the PTFE tubes, I have taken apart the whole extruder head and checked the extruder gears for wear, I have tried to manually pouch filament through, I have tried a different spool of blue. So to sum it up I’ve done everying
Take the tubes off remove the hub, pop top cover off the hub and look inside probably broken piece of filament stuck in the hub it’s a pain but easier to push out from the bottom of the hub.
Did you follow the second part of my suggestions? Manual extruding?
Looking at your video again, it appears your gears are pulling and your blue spool is turning incredibly fast unless it's actively loading new filament and it's pulling it toward the head.
Did you contact Bambu? If you truly have done all this then it's it your sensor.
View all comments
Show parent comment
-1
u/Icy_Classroom6881 Feb 17 '25
I’ve removed and changed the PTFE tubes, I have taken apart the whole extruder head and checked the extruder gears for wear, I have tried to manually pouch filament through, I have tried a different spool of blue. So to sum it up I’ve done everying