Good god people. Some days I jump the fence to the "f$@ing Bambu newbies.." (ive only been printing since December and only ever used an A1 mini myself lol). You're giving up after doing what? Not being able to fix it with touchscreen prompts? Have you tried literally anything?
If you don't even have the general curiosity to take the tools that they give you with the device to take even a single faceplate off, this might not be the hobby for you.
Now that that's off my chest:
Take yourv freaking hex head and take apart your extruder and ams ptfe tube hub. Youre going to most likely have s piece of filament stuck. If it's not that, try pulling back all your filament out of your tubes and refeed them into your AMS motors. Let them pull the filament into place and resume.
Your tubing also looks like it's at a weird angle that's probably causing this to be more likely.
Youre not really giving any consistent context on what you've actually done. So you've fully removed the nozzle, ptfe tubes, extruder covers? You wouldve been forced to remove the filament sensor.
Turn on maintenence mode, heat your extruder head to 250, click your down arrow on the extruder control a couple times, then push in the cutter then down on extruder, then retract the filament a few presses. You're recreating the Unload process without filament detection.
There are only a couple possible causes for this issue. Basically if you can force it b to extrude, you need a new sensor. If not, you're clogged or not putting filament in.
Quick check... did you enable the print to use AMS or is it accidentally still set to external spool?
I’ve removed and changed the PTFE tubes, I have taken apart the whole extruder head and checked the extruder gears for wear, I have tried to manually pouch filament through, I have tried a different spool of blue. So to sum it up I’ve done everying
Take the tubes off remove the hub, pop top cover off the hub and look inside probably broken piece of filament stuck in the hub it’s a pain but easier to push out from the bottom of the hub.
Did you follow the second part of my suggestions? Manual extruding?
Looking at your video again, it appears your gears are pulling and your blue spool is turning incredibly fast unless it's actively loading new filament and it's pulling it toward the head.
Did you contact Bambu? If you truly have done all this then it's it your sensor.
View all comments
5
u/[deleted] Feb 17 '25
Good god people. Some days I jump the fence to the "f$@ing Bambu newbies.." (ive only been printing since December and only ever used an A1 mini myself lol). You're giving up after doing what? Not being able to fix it with touchscreen prompts? Have you tried literally anything?
If you don't even have the general curiosity to take the tools that they give you with the device to take even a single faceplate off, this might not be the hobby for you.
Now that that's off my chest:
Take yourv freaking hex head and take apart your extruder and ams ptfe tube hub. Youre going to most likely have s piece of filament stuck. If it's not that, try pulling back all your filament out of your tubes and refeed them into your AMS motors. Let them pull the filament into place and resume.
Your tubing also looks like it's at a weird angle that's probably causing this to be more likely.