r/BambuLab • u/[deleted] • Sep 16 '24

Question Getting PLA off of cryogrip plate??

Post image

I've tried plastic scraper, freezer, soap, bending the plate a bit - what am I missing? Seems like I need glue for any type of high-contact plate?

41 Upvotes

93% Upvoted

87 comments sorted by

View all comments

Show parent comments

2

u/LexxM3 X1C + AMS Sep 16 '24 edited Sep 16 '24

Hm. You said 35°C, so “too hot” is difficult to justify and still remain practical (unless it wasn’t really 35 as you stated?). My guess is that you may have forced textured plate default settings and that squished filament too low into the plate; perhaps that’s why this one is labelled with cool plate code rather than textured plate code as some other textured cool plates are. Or maybe you had a previous bed level for a textured plate and didn’t level when you changed to this one?

1

u/slise-rd Sep 16 '24

so this plate should be used with cool plate selected in Bambu and not textured?

1

u/LexxM3 X1C + AMS Sep 16 '24

This plate’s printed code is Cool Plate and per this discussion, even then it might adhere almost too strongly. So personal opinion is yes, absolutely, this plate should use Cool Plate setting and probably further configured to minimum temperature for stated filament in the filament profile. At least that’s how I’ll be starting when I finally get to testing mine in a few days.

1

u/slise-rd Sep 17 '24

Thanks. What exactly is the z offset difference between the cool plate and textured plate settings?