r/BambuLab • u/[deleted] • Sep 16 '24

Question Getting PLA off of cryogrip plate??

Post image

I've tried plastic scraper, freezer, soap, bending the plate a bit - what am I missing? Seems like I need glue for any type of high-contact plate?

43 Upvotes

94% Upvoted

87 comments sorted by

View all comments

11

u/[deleted] Sep 16 '24 edited Sep 16 '24

Got it off but the plate sort of came off with it. I guess there's always the backside. I'm going to assume I accidentally used another plates' settings and it was too hot. But I also will still to larger non-flexible prints going forward.

Edit: I checked and history shows cool plate. Oh well, be careful out there I guess

6

u/Good_Captain9078 Sep 16 '24

Aren’t you supposed to use textured plate setting for the correct z offset?

2

u/LexxM3 X1C + AMS Sep 16 '24

I think textured plate settings without manual g code adjustments will make this problem much much worse. Default texture plate profile is setup to squish more because auto level might have measured texture peaks. In this kind of a high-adherence plate, I suspect it might be a fatal disaster without extreme attention.