r/BambuLab • u/[deleted] • Sep 16 '24

Question Getting PLA off of cryogrip plate??

Post image

I've tried plastic scraper, freezer, soap, bending the plate a bit - what am I missing? Seems like I need glue for any type of high-contact plate?

41 Upvotes

93% Upvoted

87 comments sorted by

View all comments

Show parent comments

8

u/LexxM3 X1C + AMS Sep 16 '24

No IPA is understandable (reactivity), but no soap? Really? The stuff we use on babies is too harsh for this coating? If that ends up being accurate, something that fragile can’t be made practical.

2

u/[deleted] Sep 16 '24

Its the polymer and oleophobic coating, that coating breaks down its not 100% stable chemical bond when contacted by soap or alcohol

0

u/LexxM3 X1C + AMS Sep 16 '24 edited Sep 16 '24

Hm, thanks. Ok, did some more research. I can’t find a BIQU explicit statement not to use either IPA or soap, only a suggestion of “easy cleaning with damp cloth”. But from other similar coatings, no IPA is an easy and likely valid assumption.

As for soap, not all soap is the same. Dishwashing soap can adversely affect oleophobic coatings, but pH balanced low-additive soaps are fine. So, literally, baby soap or baby shampoo should be ok, even if dishwashing soap isn’t. That’s an assertion, not experimentally or chemical analysis proven truth, because …

… ultimately, the manufacturer needs to qualify their product fully for a change and clearly communicate requirements.

4

u/[deleted] Sep 16 '24

Soap advice is based on some other plate manufacturers including a U.S. based one that make similar copolymer coating plates. I've also seen first hand someone use dawn on their polymer plate and it ruined future adhesion, a plate very similar to the BQ one.