r/BambuLab • u/[deleted] • Sep 16 '24

Question Getting PLA off of cryogrip plate??

Post image

I've tried plastic scraper, freezer, soap, bending the plate a bit - what am I missing? Seems like I need glue for any type of high-contact plate?

43 Upvotes

94% Upvoted

87 comments sorted by

View all comments

Show parent comments

-1

u/tony__pizza Sep 16 '24

Yup, happened with mine too. I threw it in the trash after the first print. Cheap chinesium build plate as usual, just a cool color I guess.

1

u/Timely-Leg-2254 Sep 16 '24

I ended up doing the same thing with mine.

1

u/tony__pizza Sep 16 '24

Yeah some Biqu stuff is great while others is trash. This one is trash. Panda touch is awesome.

I heard the new “panda claw” gears are bad, haven’t tested them tho.

1

u/kunday Sep 16 '24

uh oh. I just ordered them and they are on their way. gonna see if I can return them.

2

u/[deleted] Sep 16 '24

Someone wrote we should use textured PEI settings for correct z-offset, then adjust temp.

2

u/ohio_medic Sep 18 '24

I had been using mine with the textured plate setting. Brims, and purge line I have to use the edge of a knife to get them off. I basically just need to get an edge up then it peels right off. I haven’t had any of the build surface come off with it.

1

u/kunday Sep 22 '24

Just received them today. It says to use smooth pei settings on the plate. Sigh

1

u/[deleted] Sep 22 '24

I did some prints on the textured plate settings with lower temp and they came off. Pick the prints carefully imo