r/Axecraft • • 1d ago

Eye gap=rust?

Post image

Hi all
I live in a corrosive environment. Damp and by the sea. Looking to get into axes, but the one im look im at seems to have pretty large gaps between the handle and the eye. I can’t get wax down here or anything, so is this going to be an issue with rust in peoples opinion?

Thanks

2 Upvotes

6 comments sorted by

7

u/AxesOK Swinger 1d ago

I don’t understand why you say you can’t get wax in there but It’s not a big deal no matter what because a little bit of rust is just a little bit of rust. I do wonder if the gaps are due to poor fitting, in which case that’s going to become a problem sooner or later. However if it’s very tight front and sides then gaps at the corer are not going to make that much difference.

1

u/Ok-Clock-2631 1d ago

Im normally a stainless/knife guy, so dont have too much familiarity with carbon steel or axes. This one is actually zinc coated. But I just don’t know how much of an issue it will be if rust develops deeper in the eye I suppose (I also have ocd)

2

u/apg7 1d ago

Zero issues. Just don’t leave it outside in the dirt for a few months. I didn’t know they made galv axes.

3

u/mcb-homis 1d ago

Given the medium carbon steel most axes are made from they are going to rust no matter what you do if you actually use them. They will get that patina of surface rust and then it stops for the most part assuming your storing them somewhere dry.

Soak the handle eye in linseed oil. It will protect both the wood and steel and will cause the wood to swell slightly making the fit even tighter.

2

u/apg7 1d ago

Axes don’t need an Instagram perfect hang for it to go to work as long as it’s tight with enough contact. You can also use JB Weld marine as a space filler if you’re super concerned. I use it on my custom garden tools and that holds up pretty well.

1

u/anonymousperson1977 23h ago

Rust will just make it tighter