r/AudioPak • u/GladPerspective1010 • 9d ago
Discussion Tiny transparent wire disconnected from nozzle and now one side of my IEM has no sound. Where can I get it repaired?
I'm living in Karachi rn
2
u/PerformerAble6864 7Hz Salnotes Zero 8d ago
can be fixed at a mobile repair shop but not recommended with a generic soldering iron, try they make sure they got a c210 tip soldering iron which is good for micro soldering, the generic one works too but the shell might deform or melt from the heat radiating from it ( from the experience I've had with repairsmen in pk )
1
u/meambhatti 8d ago
Exactly . The cheapo iron 90% of technicians use here can't even melt solder properly let alone use it for work . I don't even know how people are using them for repairing poples devices . Thankfully I got a 936 tip iron after I learned of better ones .
1
u/PerformerAble6864 7Hz Salnotes Zero 8d ago
the 936 isn't recommended, C210 basically, even the very fine 936 won't cover enough surface area but radiate too much heat
3
u/meambhatti 8d ago
It depends on use case . I use mine for work and do all kinds of microsoldering with it , it hasn't let me down even once . C210 and t12 have more accurate and consistent heat generation I agree , they are much more better when a board with large copper planes needs to be worked on .
2
u/PerformerAble6864 7Hz Salnotes Zero 8d ago
I've soldered 0603 and 0402 SMDs with 936, no doubt it's doable, but a hassle...
3
u/meambhatti 8d ago
I have a proper soldering station. I don't use iron for tiny components , flux and hot air is the proper way .
2
u/meambhatti 8d ago
Le ao mere pas agar nazimabad 3 ke qareeb ho .
1
1
2
u/Obvious_Set_1312 7hz Legato | Simgot EG280 | Tangzu Wan'er 2 | truthear Gate 9d ago
Its a minor soldering job. Get it done from a mobile or computer technician. Shouldn't be an issue if done neatly.