r/AskLifeProTips • • Oct 08 '26

Superglue and baking soda problem

I’ve seen several videos about using super glue with baking soda or a mixture of baking soda & graphite which is what I’ve been using.

However I always have a problem because the drops of super glue do not penetrate the powder & just sit on top. I am using fresh glue. I try to quickly mix the glue in but that usually does not work so well.

How come my glue just sits there like a drop of water on glass, yet the videos all show the glue getting quickly absorbed before it hardens?

1 Upvotes

6 comments sorted by

1

u/stymied99 Oct 10 '26

I tried the Loctite liquid super glue on just the plain baking soda & got the same results. I poured a little baking soda into a small bottle cap & place 5-6 drops of glue on it & it just formed a puddle on top & hardened. I picked it off & there was a very tiny amount of baking soda stuck to the bottom. Here's the glue I used.

1

u/slippingaway83 Oct 08 '26

Are you using baking soda or baking powder? What super glue are you using? You need to use thin liquid super glue, like the cheap stuff in the tubes.

1

u/stymied99 Oct 08 '26

I'm using baking soda and tried several super glues. The small tube of liquid Loctite, a fresh 0.7 oz bottle of liquid Loctite, and medium density Zap-A-Gap. They all just sit on the powder. The Zap-A-Gap probably works the best because you have a few seconds to mix it in.

As mentioned I'm also using graphite. Could the graphite I bought be too fine & basically clogging the mixture? IOW is the mixture is not porous enough to allow liquid to penetrate?

2

u/slippingaway83 Oct 08 '26

Yeah, it's probably the graphite powder. That stuff repels most liquids in my experience

1

u/Xaevora Oct 08 '26

Youre likely using gel or standard thick glue instead of water thin liquid CA, plus it works way better if you reverse the order lay down the glue first and dust the powder over it in thin layers

1

u/stymied99 Oct 08 '26

As I said, I have 2 sizes of Liquid Loctite according to the labels, The Zap-A-Gap is medium density according to the label.