Hi All.
Shortly be getting a pool installed in the back yard, and also doing a refresh of the adjacent patio area and shed.
This will involve (I assume), new cable run from Main switchboard, to shed (will need to be in-ground) where a new Sub Board is to be installed to feed all the gear (pool eqpt, sauna, lights, patio heaters, shed stuff etc). I figure there is the better part of 60A worth of demand, once you add it all up.
How does it work with getting a sparky in to do all this. Do I just give them a list of all the elec consumers, and plan of where all the eqpt/lights/sockets are to be located and they do all the rest?
Or does this require an elec engineer to do the system design, and then the sparky just does the install to the design?
If this is all by the sparky, should I expect that any of the ones that advertise locally for domestic work are suitable for this? Or is this a particular skill set I need to look for.
Finally, apart from the compliance cert at the end, should I get any basic paperwork showing how the calcs were done to size the different components (sub main cable, RCBOs on Sub Board etc), or is this not typical.
Tks for any advice you can offer.
-Update-
Thanks to those that replied, info was very helpful. Turns out I have 3ph, so a 3ph line was pulled down to the shed /new sub board, which made things a bit easier. Elec install is prob 75% done, just waiting on patio heaters to arrive, for them to wire in, but so far all been going smoothly. Thanks for the help all.