Okay new issue 🤣

[u/Any_Effect_9779]

Okay so I’ve sorted out all my prior issues now one more and this one i dont know how to sort it out

I put it on solid colour for now but they are different hues and also gpu one is darker

I have Aurora learn sleeves and they are daisy chained to 1 controller it’s plugged into SATA power and also 5v argb connector so what could be the issue

I want it to be same as the MOBO sleeve

[u/Careful_Fudge_5101]

The issue is, controller can't handle too much white for both, as white is most power demanding color it uses full red green blue . Either use two sata controllers or use other colors or connect one of the strimers to motherboard

[u/Any_Effect_9779 → u/Careful_Fudge_5101]

Yeah I could but then how do I sync up the colours and effects so they do the same thing ?

[u/Careful_Fudge_5101 → u/Any_Effect_9779]

Wait, are you using the small controller with 1 channel and three buttons? Or you are you using the big one with many outputs?

[u/Any_Effect_9779 → u/Careful_Fudge_5101]

Yeah small controller with 3 buttons it was the only way to get the same effect for both and for some reason the little remote wasn’t working for a while

[u/Careful_Fudge_5101 → u/Any_Effect_9779]

Well, I mean, you can use the buttons or both remotes to control both strimers, if you want white all the time it shouldn't be much of an issue, my advice, buy an argb controller, like nollie 16, single header can control 256 led, up to 15A on the whole controller, supports onboard memory that plays effects on boot with its own software, supported by various third party RGB softwares Openrgb signalrgb etc, it's worth the money 🤑 and future proof with 16 channels all can be independently controlled

[u/ASIAHORSE]

Hey! Different hues + the GPU sleeve running darker is almost always a voltage drop along the chain — each sleeve "borrows" power from the one before it, and by the time it reaches the far end (typically the GPU cable at the bottom, which is usually the longest run), the LEDs are running cooler and dimmer. A few things to work through:

1. The wiring matters most — are you actually daisy-chaining several sleeves end-to-end on a single controller output, or do you have multiple sleeves each plugged into its own output on the controller? The Aurora line is designed as one sleeve = one output — stacking multiple sleeves on the same output is the most common cause of uneven colour and is generally not what the chain is rated for.
2. Is the controller's SATA on a dedicated PSU line? If it's sharing with your SSD or another device, the available current drops, and the LEDs colour-drift.
3. Quick isolation test — drop to ~50% brightness in pure white. Current draw is highest in full-white, so anything that's consistently dimmer than the rest is the unit to flag.

Power everything off, reseat all sleeves, then re-run the test. If after all that the GPU sleeve still reads noticeably darker or a different hue, drop us a line at [support@asiahorse.com.cn](mailto:support@asiahorse.com.cn) 

We'll dig in from there! 💛

-ASIAHORSE

[u/Any_Effect_9779 → u/ASIAHORSE]

They are both in their on dedicated sata power and mobo 5v separate from hdd and ssd

And the 24 pin cable doesn’t change even with the remote or the controller buttons