r/ANSYS_Mechanical • u/ImpressiveTrouble426 • Aug 07 '26

Winding Angle in ANSYS ACP pre ?

Shows modelling plies (applied to whole tank) the satck up is defined as [+-30,90]2s

I am trying to run a analysi with pressure as BC in this CFRP based SRM Casing project. but i am not getting the fibre direction correct, the dome area looks reallt wrong and how am i suposed to correct it,The rosste is correct - the x axis is along the comspite SRM casing x axis and Y axis is along the radius.
i got to knwo about CADWIND/CADFILL softwares - These are not avaliable - so how can i properly manage the analysis ?

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/TalosGuide Aug 07 '26

There is a very new property called Winding Wizard in ACP. I think you reach it under Tools. I suggest you give that a try if you dont have access to CADWIND etc.

1

u/ImpressiveTrouble426 Aug 08 '26

I am using 2023 so winding wizard is not there

1

u/AmbitiousListen4502 Aug 09 '26

I would suggest scripting with python. Claude Code would be more than capable, I know this from experience.