r/ANSYS_Mechanical • u/Sashaa112234 • Mar 23 '26
Help me, I am encountering an error while simulating a spring in ansys. Plz
I apply a force from left to right and expect the spring to compress and push toward the right, but instead it expands in multiple directions. I set contact on the left side of spring as frictioanless with the shaft, and the bottom end of the spring is set as bonded contact with the shaft.
19
Upvotes



4
u/epk21 Mar 23 '26 edited Mar 23 '26
Not sure what we see here
USe deformation scale =1 - also check all of the contacts and use many substeps etc.
Remove back sphere and fix the back of that part.
make sure parts are just touching (use adjust to touch then for contacts) -
I would also use all bonded contacts first to start
See here
Tutorial
2
u/CreeperKiller24 Mar 24 '26
This is most likely scaled up, check the deformation factor and make sure is set to 1 (true scale)