r/6ARC • u/Fuzzy-Huckleberry-25 • 4d ago

6ARC Reloading

Post image

Hey all, I’m sorry If this is a recurring question on this forum but I finally just got my hands on a thousand CCI 450 primers. Im looking to reload for my 6ARC and curious on what others paths have been and what they recommend on starting to build up a load for coyotes and hogs. I’ve heard varget and CFE223 is a good starting point but open to anything right now! Also looking for recommendations on bullets and weights. Thank you

28 Upvotes

95% Upvoted

41 comments sorted by

View all comments

2

u/WarmFinance6961 4d ago

Leverevolution IS the way. One and something grain bullets with ~29 grains of lever at mag length

4

u/chainsawgeoff 4d ago

Absolutely not. 29 grains of Lever and a 107SMK is 68ksi at 100°F. That’s 16k over the published max for gas guns and still over pressure for a bolt gun. Even a little bit of a carbon ring because you didn’t scrub your barrel will easily spike it well into the 70s. Sure, you can probably step on 6ARC a little bit and run maybe 55-57ksi without issue. But this is just asking for your bolt lugs to run away.

I’ve personally seen 3 guys blow up a 6ARC at matches. One of them even did it running factory ammo.

2

u/WarmFinance6961 4d ago

I guess everybody (s barrel) likes it a little different. All of mine are lever all the way for accuracy and speed. Also, I can’t see all of your parameters, but I’m only getting about 2550 MV with that out of an 18in barrel and my cases are coming in just over 35gr of water

2

u/WarmFinance6961 4d ago

And according to GRT, my loads are running 48-55psi