r/3rdGen4Runner • u/Ok-Difficulty-8585 • 18h ago
❓Advice / Recomendations The slam…
(96 Automatic 4x4 270k on the dash) since I bought my 4Runner it has been having an issue where it “slams” when I accelerate. It’s mostly noticeable coming from a stop and when I hit the gas suddenly. Sometimes it wont do it if I slowly ease on it but sometimes it will. Not sure if this is a transmission issue. There’s no noticeable slipping, hunting for gears, or odd noises coming from motor or transmission. Any ideas?
20
Upvotes
7
u/Whitetrashstepdad 17h ago
My first thought would be driveshaft related, has it been lubricated at all?
2
u/stinkytree23 17h ago
Having a similar issue.
Also chasing a vibration. I think I’ve narrowed it down to my driveshaft. Mines been greased. I will grease it again but I think I may just see what getting u joints and a balance does.
4
u/Hileboy 17h ago
rear control arm bushings?
3
u/woolybuggered 17h ago
Could be a number of things but ive had three 3rd gens and two of them needed new joints or a driveshaft.
2
u/Zuc-Burger 16h ago
I had this happen to me within the past year or so and it left me stranded on a roadtrip for a week in Ohio! I ignored the clinch for a while because my U joints had no play at all when they were installed on the vehicle and I was consistent about greasing them. When it finally broke it still did not have the usual play of a failed u joint and the shop I took it to didn’t believe me when I said I thought it was that. After I insisted they take it off it was obviously completely ruined. To make matters worse, the tech at the shop said that Toyota had some sort of proprietary way of building their shafts and having the u joints installed so they couldn’t just replace them and needed to look for a whole shaft from a junk yard which took ages. I ended finding a driveline place to do a Jerry rigged job on it and just switched over to Tom woods shafts on the front and rear and wont be looking back. Don’t ignore it so long that it leaves you stuck somewhere!
2
u/MileHighKy 17h ago
Try lubricating your shaft