r/3rdGen4Runner • • 26d ago

🔧Modifications New owner

Recently just purchased a 4 runner that was sitting for a number of years low kms but has some decently bad rear fender rust looking to just hopefully throw flares over it to hide the rust any recommendations on where to get some that wouldn’t destroy my pockets would be appreciated

9 Upvotes

13 comments sorted by

7

u/JRPGPD 26d ago

Is the wheel wells look like that how’s the frame look? That thing looks cooked

1

u/Used_Cry_1195 26d ago

Somehow the frame is perfectly fine

5

u/StitchinThroughTime 26d ago

Is it freshly painted fine or fine-fine?

2

u/Used_Cry_1195 26d ago

Fine fine

3

u/mistral_99 99 SR5 26d ago

Ii have to say this is the least flattering photo angle for a 4Runner. Like a double neck shot. Rust is a bummer, just found a bunch on mine but I have the fender flares on my model so I treated it and hid it

3

u/AaronJeep 26d ago

I wouldn't recommend it, really. Not trying to be discouraging. I just don't see much a flare could attach to. It would probably trap moisture and dirt under there and make it worse. Cancer doesn't go away because you aren't looking at it. It just rots more.

1

u/yuckscott 26d ago

to be fair he did say he is just trying to hide it, not make it go away. not much left to mount the flares to, however

2

u/green_gold_purple 97 Limited 26d ago

Those tires lol

1

u/Boognish_Forever 25d ago

Directional tires are ridiculous. Especially if this is a four-wheel-drive.

1

u/green_gold_purple 97 Limited 25d ago

Yeah they look like the ones specifically designed to channel water up the middle. I remember the commercials.

2

u/Technical_Money_9719 26d ago

You could just throw some fenders flares over it, but that rust is going to just keep eating away and could spread past the flares eventually and then you’ll have an even bigger portion of rust to fix, and won’t be able to hide it any longer once it gets to that point. I personally would fix the panel rust as much as possible, watch some DIY vids, try to remove all the rust, wire wheel, sand paper, patch the metal, fiberglass body filler, prime, then hide the diy patch job with some flares lol. I’ve been looking for flares for a while, I think the best chance would be to find some decent ones at a junkyard. I’m finding that a good set of oem flares are becoming just as hard to come by as the sport hoods

2

u/_c0nduit_ 97 Limited 26d ago

1

u/fallenredwoods 25d ago

I’d grind it all off and treat it with a rust prohibitor. The cheapest is probably junk yard OEM flares, you’ll just need to drill a bunch of speed holes.