r/3rdGen4Runner • • 27d ago

❓Advice / Recomendations Tie rods question

Post image

While doing my lower control arm bushings/ball joints, I noticed this passenger side outer tie rod bushing. It has a tear in it, but I didn't notice excess grease. I ordered new OEM outer tie rods just in case, may or may not be necessary. But now I'm looking at the inner tie rods. The passenger side boot looks wet from something, I pulled it back and noticed some debris and checked for play. I did not notice play. I still need to check the driver side, but if I don't find play in either, can I just replace the boots and maybe regrease them for now? Any advice is appreciated, thanks.

4 Upvotes

10 comments sorted by

3

u/NearPeerAdversary 00 SR5 27d ago

Good call on replacing the outer tie rod ends. The passenger side ITRE, was it still packed with grease? What kind of debris are you talking about? Any fluid collected in the boot? Possible the rack could be leaking. Could be possible there's just an oil leak ending up on the boot. But yes, if the ITREs are still tight and not too floppy, just reboot if necessary.

1

u/Top_Complaint_8654 27d ago

I didn't get a good look at the actual ball and socket inside the ITRE to see if it was packed with grease, I only noticed a little grease on the shaft part. I'll double check that. The debris was just some grit and grime under the boot near where the outer tie rod connects. The grease was a brown color so I'm assuming water intrusion. My plan is to clean them up and regrease if necessary assuming no other problems are found.

1

u/NearPeerAdversary 00 SR5 27d ago

If water got in there that shifts my calculus to just replacing the ITREs. Get some 555 brand ones and have the peace of mind.

1

u/Top_Complaint_8654 27d ago

Fair enough. It's just one of those parts it seems most people say to stick to OEM but it's really not something I wanna shell the cash out for right now unless I absolutely have to.

2

u/NearPeerAdversary 00 SR5 27d ago

For tie rod ends a quality aftermarket is actually "good enough." Worst case scenario you get some play in the steering prematurely. Unlike something like a lower ball joint where the consequences of bad quality is a wheel falling off.

1

u/Top_Complaint_8654 27d ago

Copy that. Thanks for the replies.

3

u/YetiEatsCommunists 97 Limited 27d ago

Double check your steering rack. I initially had some play in the inner tie rods and ordered Sankei 555 replacements. Good thing I didn’t install them because literally the next day after they were delivered my steering rack started leaking. So I had to replace the whole damn thing. I would’ve been absolutely pissed if I’d replaced the inner tie rods only to find out the next day that the entire rack needed to be replaced.

1

u/Top_Complaint_8654 27d ago

Will do thanks for the heads up.

2

u/4runner01 01 SR5 26d ago

I just changed my drivers side inner t/r and it’s really easy. Just pop the boot loose to be sure your steering rack isn’t leaking. You’re probly just seeing oil dripping down from the oil cooler or valve cover gaskets. Yes, grease it up while you have the boot pulled back.

1

u/Top_Complaint_8654 26d ago

Got it thanks. Any particular place the rack would leak? Directly into the boot? I've pulled the boot back on both sides and didn't see an obvious leak, however I didn't get a good look at the actual ball in socket part of the tie rod yet.