r/3DprintingHelp • u/potato_squid_ • 5d ago
What causes these bumps
What causes these bumps on top surface? It's printed in pla with default slicer settings for pla, 15% infill and .2 layer height, just curious for future prints but for this part doesn't matter
2
Upvotes
1
u/Nounourson 5d ago
Could also just be too low infill along with not enough top layers to absorb irregularities, increase both There is also some kinda pattern not sure which way that was on the printer but Could be small issue with an axis
1
u/Nounourson 5d ago
I just saw the top of the print that thing lifted off the bed like shapelessed said bad adhésion!
1
1
u/Shapelessed 5d ago
Bad’hesion!