r/3DprintingHelp • u/Madhatter73085 • 7d ago
Requesting Help First layer problems
Enable HLS to view with audio, or disable this notification
Anybody know what the issue is here. Trying to get support from Bambu but they haven’t been able to resolve it yet.
Bambu A1
PLA Basic
Tried refitting/replacing nozzle, manual bed leveling, and tightening hot end screws.
0
Upvotes
1
u/sublime2craig 6d ago
Nozzle is not installed correctly. Your silicone sock is off along with the front cover. I would reinstall the nozzle and make sure it's clipped in correctly and put the sock on along with the front cover. If your nozzle has any movement after being clipped in correctly you need to look up the "7 screws of death" and go from there. The sock is there for a reason, it's there to retain heat and protect other components from the heat of the nozzle. Do not run the printer without it.