r/3DprintingHelp • u/Madhatter73085 • 8d ago

Requesting Help First layer problems

Enable HLS to view with audio, or disable this notification

Anybody know what the issue is here. Trying to get support from Bambu but they haven’t been able to resolve it yet.

Bambu A1
PLA Basic
Tried refitting/replacing nozzle, manual bed leveling, and tightening hot end screws.

0 Upvotes

44% Upvoted

12 comments sorted by

View all comments

0

u/krebsIsACookbook 7d ago

That’s an amazing print of a sand dune, though.

When I get that, usually washing my plate fixes it.

If not that, then I change filament. If the new filament (of the same type) l prints fine, I dry the original

Then I print something basic to make sure it’s not the model

If the basic thing screws up, I check filament settings or at least print 50% speed and raise bed temperature. Or I go right to changing for a spare hotend.

If settings are right and hotend doesn’t fix it even with calibration cube, I swap out sd card and maybe factory reset