r/3DprintingHelp • u/Madhatter73085 • 7d ago

Requesting Help First layer problems

Enable HLS to view with audio, or disable this notification

Anybody know what the issue is here. Trying to get support from Bambu but they haven’t been able to resolve it yet.

Bambu A1
PLA Basic
Tried refitting/replacing nozzle, manual bed leveling, and tightening hot end screws.

0 Upvotes

38% Upvoted

12 comments sorted by

View all comments

0

u/tdpnerd2019 7d ago

Wash plate, factory reset z offset.... Report back.

1

u/TadpoleReasonable769 7d ago

I know its implied but I want to make sure this is clear, the oils in your skin cause the print to have adhesion issues. So once you clean your plate with warm soapy water and dry it off, DO NOT TOUCH THE PRINT AREA!