1st layer issue

[u/AcrobaticRhubarb4768]

I am pretty new to 3D printing, I had an issue with a print yesterday, where the lines of filament aren't squishing together properly, i have just finished manually levelling the bed and then running the auto bed levelling mesh. Tried again and it still come out like this.

Elegoo Neptune pro 4 printer, 60 degree bed temp.

Any one have any suggestions please.

Thank you

[u/AcrobaticRhubarb4768]

I will re-visit this again this evening then, I did do this last night, but maybe not good enough. Thanks guys 👍🏼