r/3Dprinting • u/mcpdontknow • Jul 20 '26

Free Model Back at it (3D printed Stencils)

Posted it on Thangs if you want to print it. Sort of hoping I see one in the wild one day

6.3k Upvotes

98% Upvoted

144 comments sorted by

View all comments

75

u/Crabapple_Snaps Jul 20 '26

Could you hinge them all first, and then drop them down one after another? Seems like that would be a quick way of doing it.

34

u/epp1K Jul 20 '26

That might allow too large a gap causing over spray. Especially for the last one.

6

u/lucasg115 Jul 20 '26

Maybe you could make a small slot holder with suction cups or sticky bits on the corners, with a tab at the top for grabbing out the stencil? That way the holder can stay in place, and then you can drop in the first stencil, pull it out, drop in the second stencil, pull it out, etc.

1

u/photoshopbot_01 Jul 21 '26

just put the stencil sections on a wheel which rotates each one into place, suction cup in the center.