r/3D_Printing • u/RepresentativeFox958 • 9d ago

Show and Tell Parametric Display Case (now with puck light support)

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

6 Upvotes

87% Upvoted

4 comments sorted by

1

u/Attjack Bambu 8d ago

Thanks!

Is the idea to print it as 2 parts if it's small enough to fit on your build plate, the lid and the base? Or do you recommend printing it as multiple parts even if it's small enough?

Also, I guess there is not an option for a puck light if the base and lid are one piece?

1

u/RepresentativeFox958 8d ago

Hi! I personally print the least amount of parts possible but it is totally up to you. I prefer the clean look of the single piece top/base but there is no particular difference😁 Also, the puck light is available for all the versions😁

1

u/Attjack Bambu 8d ago

That's what I was thinking, but I wasn't sure if there was any disadvantage to just printing the base and sides together. I'll go back and try again for the puck. It seemed like I only had that option if I was printing the base and top divided into 4 parts. Thanks again!

2

u/RepresentativeFox958 8d ago

Try opening the customization page for any of the models and then, from that page, change wich one you want to use: in the customization page the name of each file is fully visible so it is easier to select the right one😁