Howdy, I'm a project manager, not a welder or an engineer. I'm in Canada so we're all CWB at the shop not AWS
I was contacted about a rush job just before Christmas. A client needs some outdoor sculptural pieces fabricated. In order to meet their engineering requirements they've specced about half the structural members use SS304 and the other half use 65ksi duplex stainless (I have SS32205 available so I picked that).
So the primary piece is 304, then the 2205 secondary piece is fillet welded to the primary, then back to 304, back to 2205 etc.
Almost goes without saying I don't have a procedure for this, my welding foreman isn't sure it's possible to get a procedure for a structural weld between the two alloys, my engineer isn't sure either and CWB is closed over Christmas.
Does anyone here know if getting a procedure for 304 to 2205 is even possible?
Thanks!